Leikr forum

A new software update is now available!

We have great news for our cycling Leikr members, this software release will enable integration with:

ANT+ Combined Bike Speed and Cadence sensor support.
ANT+ Bike Speed sensor support.
ANT+ Bike Cadence sensor support.
Along with it we made some other important upgrades.

The watch now reconnects automatically to paired ANT+ accessories.
We have improved the routine for downloading routes from Endomondo.
We have improved the autopause handling for the "Indoor" profile.
Wi-Fi connectivity is in general more stable.
The Software update with be available for download in a short while.

We are looking forward to your feedback!
Thanks!
The Leikr Team

Unable to get the software update. Multiple attempts, but I only get "No new firmware is available"
current firmware: 1.9.27 (b)

Thanks for reporting, redlace.
It should work now.

br.
Nikolaj

just updated... all good.. nice work on the update..

Hi!

Version update done right now. Fine new feature.
ANT+ Speed/Cadence Sensor found with ID 3610. Its from o_synce the "Macro 2SXcom" Device.
In cycling mode i cadence works fine, but no speed values was shown. Is it done only when i have GPS speed info too?
How does you calculate the value within GPS and speed sensor. Is there a synctime for calculate the correct weelsize.

Good point! Will it be displaying speed the speed sensor or from the GPS? If from the speed sensor, the wheel size would have to be recorded somewhere.

Just been out with the latest firmware, I can scan for the speed / cadence sensor, however speed is never show even though the correct wheel size has been entered.
If you stop for more than thirty seconds the cadence seems to hang on the last value and never reconnects unless you scan for the unit again.
(The ANT+ unit has been working with no issues with my Samsung S5 with Endomondo.)
I also have a ANT+ HRM which appears to maintain its connection with the watch all the time.

Team Leikr -
having issues with the software update. After finally getting access to the server, I was able to download and install the firmware, and the device successfully returned to the home screen.
Unfortunately, I came to a full, dead, stop at that point.
I turned off the device to save battery power for a workout later in the day.
When I turned the device back on, it froze at the "squares in four corners" screen.
I used the four-button long, long, long, long, long press to get to the reset/reboot screen, and rebooted the device.
The device eventually rebooted and froze at the "squares in four corners" screen again.
I did this two more times, with the same results.

So I went for a run with the Endomondo app on my iPhone. It worked.

When I got home, I did a complete factory reset and put the device in the charging cradle.
I downloaded and re-installed my config file.
I turned the device off and on again, and attempted to sync it several times from the home screen. Every time = "unable to connect to the Leikr server"

I did another factory reset and re-installed my config file again.
I turned the device off and on again, and attempted to sync it several times from the home screen. Finally, after many attempts I was able to connect to the Leikr server. At that point, I got "device settings received from Leikr server," "uploading to Endomondo complete, "downloading Endomondo routes," etc, and a software update reset.

I then conducted a sync prior to shutting down the device again and got all my maps back.

This process is sub-optimal.

> If you stop for more than thirty seconds the cadence seems to hang on the last value and never reconnects unless you scan for the unit again.
I have same experience. always the last positiv value is displayed. We need the zero.

Dear Leikr Team,

I have the same problem as redlace.
After the softwareupdate the watch works without any issues. After turning off and on it froze at the starting screen.