Leikr forum

Hi Guy's,

since last release 1.10.28 i have some strange gps problems.
It happens 3 times, that the gps is gone, which is not unusual. But then the display switched between "00" for satelites to "zZ" and vice versa.
Then it switched from "00" to for example to "05" updates the postition on the map and switched immediately back to "zZ".
When I switched off the watch and on again, it were back to normal. 2 times it happens after a break, i have on "Auto Pause".
You can see where I did the breaks on the track, it looks like the watch doesn't recognised it.

Here are some examples:

http://www.endomondo.com/workouts/361560882/8937188 -> see the points at the end of track.

after stop - switched on and off again:
http://www.endomondo.com/workouts/361560995/8937188

next day same again:
http://www.endomondo.com/workouts/361561097/8937188 -> see the points at the end of track and you can see where i did the break

after stop - switched on and off again
http://www.endomondo.com/workouts/361561175/8937188

Could you please have a look at this or is it expected behavior?

Regards Gerhard

Hi Gerhard.

Are you using an external power supply, like a battery pack or a bike charger, during your ride?

br.
Nikolaj

Hi Nikolaj,

i construced a 3D-printed bike mount with an integrated powersupply.

Regards Gerhard

Ihave the same issue, since the last update. I do not use external power supply. After several reboot's and a factory reset (again) it seems to work. At the beginning I changed to indoor sport and back again, the the display changed from zZ to 00, but still no gps signal!

I have seen that as well once. I have also seen the GPS fixed satellites number change to to "--"